欧美一级久久久久久大片,免费A片全黄少妇7777,WWW.色色色色,国产剧情无码视频在线播放

Product Details

  • Product name：IEC60884 FIG11 Wire damage test device for pull testing

  • Product number：IEC60884 FIG11
  • Product manufacturer：Chuangxin
  • Product documentation：
你添加了1件商品 查看購物車
a brief introdction：
IEC60884 FIG11 Wire damage test device for pull testingThe wire damage test device is a special test instrument designed and manufactured according to the requirements of IEC884 Figure 11, , etc. It is mainly used to judge whether the screw-clamp type terminal is in design and structure.
Details description：

IEC60884 FIG11 Wire damage test device for pull testing

Product Description
Application 
The wire damage test device is a special test instrument designed and manufactured according to the requirements of GB119.1-2008 Figure 11, IEC884 Figure 11, GB1314.3, etc. It is mainly used to judge whether the screw-clamp type terminal is in design and structure. It meets the requirement of not damaging the wire when it is clamping the wire, and it is also used to check whether the screwless terminal has withstood the mechanical stress that occurs during normal use. 

Working speed
10±2 r/min
Casing size
6.5 mm
Radius of rotation
37.5 mm

9.5 mm
Adjustable height
260-320 mm

13mm
Power supply
220V AC/50Hz

14.5 mm
Environmental requirements
0～40°C/relative humidity≤80%
Standard
IEC60884、GB2099
Counter weight
100g、200g、300g、300g、1100g

The normal test  
1 Scale adjustment: Loosen the fixing nut at the scale position, adjust the fixture to the height required for the test and fix it.
2 Center adjustment: Use the line hammer to find the center of the turntable.
3 sample installation:  
? The terminal block is connected to the corresponding wire and installed and clamped.  
? Pass the wire through the corresponding casing and install the corresponding weight. 


normal test steps: 

 Set the number of tests according to the test duration (after each change, press the reset button to eliminate the number of previous settings) 
 Press the “Start” button, the device will start running, and the turntable will rotate at 10 revolutions per minute. After the number of trials is reached, the test will automatically stop and an audible prompt will be given. 
 Press the yellow reset button to release the sound prompt. After the test, disconnect the power switch and cut off the working power. 

Nominal cross-sectional area of the wire mm
Casing hole diameter mm
Distance(H)mm
Heavy object corresponding to the wire（Kg）
0.5
6.5
260
0.3
0.75
6.5
260
0.4
1.0
6.5
260
0.4
1.5
6.5
260
0.4
2.5
9.5
280
0.7
4.0
9.5
280
0.9
6.0
9.5
280
1.4
10.0
9.5
280
2.0
If the diameter of the casing hole is not large enough, to bundle the wire into the casing hole, you can use a larger size casing.
Distance (H) deviation ± 15mm
There are 2 threading holes on the turntable of the machine. The inner diameters are 6.5mm, 9.5mm, and the 13mm wire sleeve can be replaced by the installation test. The rotation radius of the hole center is 37.5mm.

粵公網安備 44030602001691號